Extron Electronics IN1508 User Guide - Manual (Page 70)

Bulk cables
Cable Part number
IN9700/6 DVI male to male 6 ' (1.8 meters) 26-584-06
IN9700/25 DVI male to male 25 ' (7.6 meters) 26-584-01
IN9700/35 DVI male to male 35 ' (10.6 meters) 26-584-02
IN9700/50 DVI male to male 50 ' (15.2 meters) 26-584-03
IN9700/75 DVI male to male 75 ' (22.8 meters) 26-584-04
Rack Mounting
The IN1508 comes with rubber feet and a set of rack mounting brackets.
Tabletop Use
Attach a self-adhesive rubber foot to each corner of the bottom of the switcher.
Rack Mounting
UL guidelines
The following Underwriters Laboratories (UL) guidelines pertain to the installation of the
switcher into a rack (figure 36).
1. Elevated operating ambient temperature — If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may be greater
than room ambient temperature. Therefore, install the IN1508 in an environment
compatible with the maximum ambient temperature (Tma = +122 °F, +50 °C) specified
by Extron.
2. Reduced air flow — Install the equipment in a rack so that the amount of air flow
required for safe operation of the equipment is not compromised.
3. Mechanical loading — Mount the equipment in the rack so that a hazardous condition
is not achieved due to uneven mechanical loading.
4. Circuit overloading — Connect the equipment to the supply circuit and consider the
effect that circuit overloading might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when
addressing this concern.
5. Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to supply connections other than direct connections
to the branch circuit (e.g. use of power strips).
Mounting instructions
Rack mount the switcher as follows:
1. Attach the rack mounting brackets to the switcher with the supplied eight #8 machine
screws (figure 36).
2. Insert the switcher into the rack, aligning the holes in the mounting bracket with those
in the rack.
IN1508 • Reference Information 65