Extron Electronics IN3526vi - Manual (Page 12)

8
IN3526VI OPERATION MANUAL - REV. 2 12/01/98 ©1997 - INLINE, INC.
RS-232 COMMAND PROTOCOL
Command* Function Response*
ACI3 Set baud rate to 1200, default setting OK
ACI4 Set baud rate to 2400 OK
ACI5 Set baud rate to 4800 OK
ACI6 Set baud rate to 9600 OK
ACI7 Set baud rate to 19200 OK
BLANK0 Blank output (no input selected) OK or CH1
BLANK1 Un-blank output (selects previous input) OK or CH1
CH0 Blank output (same as pressing the front panel BLANK button) OK or CH1
CH1 Select Input 1 OK or CH1
CH2 Select Input 2 OK or CH1
CH3 Select Input 3 OK or CH1
CH4 Select Input 4 OK or CH1
CH5 Select Input 5 OK or CH1
CH6 Select Input 6 OK or CH1
CMDCD0 Select "[" & "]" OK
CMDCD1 Select "{" & "}" OK
CMDCD2 Select "(" & ")" OK
CMDCD3 Select "<" & ">" OK
SCAN0 Disable scan mode OK
SCAN1 Enable scan mode OK
SCANx Configure scan to scan up to channel x where x = 2 to 6. OK
SCANTx Set scan time as follows:
x = 1: 2.5 seconds
x = 2: 5 seconds
x = 3: 7.5 seconds
x = 4: 10 seconds
x = 5: 15 seconds
x = 6: 20 seconds
x = 7: 30 seconds
OK
FP Enable/Disable the front panel (toggle) OK
FP0 Disable the front panel OK
FP1 Enable the front panel OK
INF0 Get the firmware version IN3526VI V1.0
INF1 Get the currently selected input 0 to 6 (0 is for Blank)
* Command codes are not shown for clarification purposes.
RS-232 SAMPLE COMMANDS
Description Command Response
Switch to Input 2 (for a Slave switcher) [CH2] [OK]
Switch to Input 2 (for a Master switcher) [CH2] [CH1]
Get status of input selected [INF1] [2]
Disable Front Panel operation [FP0] [OK]
Change baud rate to 4800 [ACI5] [OK]
Change command codes to { } [CMDCD1] {OK}