Extron Electronics MTP AV Series Setup Guide - Manual

IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
MTP AV Series • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate any of the Extron
Mono
Stereo Jumpered for
Mono (Default)
MTP AV transmission systems.
Pre-installation — Jumpers
The units are factory-set so that one unit cannot remotely power another and to handle mono audio.
They can be set to handle stereo audio and provide remote power. A stereo audio unit is only
compatible with older generation units.
The appearance and location of the jumper block change with each unit. See the illustration above or
see the MTP AV Series User Guide at
www.extron.com to set the jumpers for the units to be installed.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and receiver as required.
Step 2 — Transmitter Inputs INPUT
L R
S-VIDEO
INPUT
VIDEO
L R
NOTE: The illustration on the right shows the available connections. Your unit may look different.
z Plug a video source into the applicable input connector:
z
S-video input connector — A 4-pin mini DIN (Y/C) connector
z
Composite video input connector — A female BNC connector
z Plug an audio source into the applicable audio input
LR LR
Unbalanced Stereo Input Balanced Stereo Input
(high impedance) (high impedance)
Ring
Sleeve (s)
Tip
Sleeve
Tip
Sleeve
Tip
Tip
Ring
Do not tin the wires!
connector:
z
5-pole captive screw connector — Wire the connector
as shown on the right.
z
Two RCA connectors
Step 3 — TP Cables Between Units
ATTENTION: Damage to the unit may occur if TP cables
are mis-wired as crossover cables.
Terminate a TP cable as shown in the figure to the right.
Connect it between the output port of the transmitter and
the input port of the receiver.
Step 4 — Receiver Outputs
z
Plug a video display into the applicable output connector:
z
S-video output connector — A 4-pin mini DIN (Y/C)
connector
z
Composite video output connector — A female
BNC connector
z
Plug an audio device into the applicable audio output
connector:
z
5-pole captive screw connector — Wire the connector as shown below.
z
Two RCA connectors
ATTENTION: Connect the sleeves to ground ( ). Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.
1
MONO AUDIO
2
1
MONO AUDIO
2
Unbalanced Output Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
Pin T568A
Wire Color T568B
Wire Color MTP Signal
Composite / S-video
1 White-green White-orange Reserved / Chroma+
2 Green Orange Reserved / Chroma-
3 White-orange White-green Mono Audio+
4 Blue Blue Video+ / Luma+
5 White-blue White-blue Video- / Luma-
6 Orange Green Mono audio-
7 White-brown White-brown Reserved
8 Brown Brown Reserved
NOTES:
• If you are using Enhanced Skew-Free™ AV cable, use the
TIA/EIA T568A standard only.
• The pin assignment is different if you have shifted the jumpers in
“Pre-installation — Jumpers” above (see the MTP AV Series User
Guide).
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins: