Extron Electronics P-2 DA2xi MT Setup Guide User Manual
Setup guide — p/2 da2xi mt, Installation, Step 1 — power down and mount
Setup Guide — P/2 DA2xi MT
This guide provides basic instructions for an experienced
installer to set up and operate the Extron P/2 DA2xi MT.
Installation
The P/2 DA2xi can be mounted on a rack shelf, under a
desk or tabletop, or on a projector bracket.
C
Installation and service must be performed by authorized personnel only.
AUDIO
INPUT
MONITOR
L
R
P/2 DA2xi MT
OUTPUT
1
ON
2
EXT POWER (see manual)
5V
0.2A MAX
GAIN/PEAK
OUT IMP
7
6
1
3
4
75
66
2
6
9
67
68
Step 1 — Power down and mount
Turn off or disconnect all equipment from power sources and mount the P/2 DA2xi MT as
needed. Refer to the user’s guide for mounting details.
When lit green, Power/Signal indicator LED (
a
) indicates that the distribution amplifier is
receiving both power and a computer signal. When it is lit amber, it indicates that the
P/2 DA2xi MT is receiving power but no computer signal.
Step 2 — Connect inputs
•
Connect a 3.5 mm, mini audio plug cable from the sound
card of the PC to the audio input connector (
b
). Wire the
audio plug as shown on the right.
•
Connect the VGA-QXGA output of the PC to the 15-pin HD
video input connector (
c
).
•
Connect a local monitor to the 15-pin HD monitor input connector (
d
).
N
A local monitor cable assembly (
i
) can be chained to the unit to prevent it from being
misplaced.
Step 3 — Connect outputs
•
Connect the video output device (projector, display panel, or monitor) to the 15-pin HD
video output connector (
g
).
•
Connect a 3.5 mm, 5-pole, captive screw audio connector to the 5-pin audio output
connector (
h
). Connect the other end of the audio cable to an audio output device.
See the audio wiring diagrams on the other side.
(Continued on reverse side)
Sleeve ( )
Ring (R)
Tip (L)