Extron Electronics SMB 1 Installation User Manual
Smb 1 • installation guide, Mount the smb 1 directly to furniture or a wall
SMB 1 • Installation Guide
The Extron SMB 1 surface mount box ships with the included
parts shown in the figure to the right. It offers a variety of
mounting options for the TLP PRO 320M and TLP PRO 520M:
z
Stand the box on a suitable surface — The SMB 1 has
two anti-skid pads attached to the bottom that allow it
to stand on a suitable surface without attaching it to the
surface.
z
Mount the box with a Swivel Mount Kit — The SMA-1
swivel mount adapter kit (not provided) allows the SMB 1
to be permanently mounted for security, but rotated to
provide access to the touchpanel from around the table.
See the SMA-1 Installation Guide, at
before installing the SMB 1.
z
Permanently attach the box to a glass surface — Use
the optional GMK 1 kit (not provided). See the GMK 1
Installation Guide, at
.
z
Secure the box to a suitable surface — This allows the
SMB 1 to be permanently secured to a table-top or wall
(see “Mount the SMB 1 Directly to Furniture or a Wall,”
below).
Bottom Cable
Access Plug
Strain Relief Clamp
Cable Wrap
Strain Relief Boot
SMB 1
Rear Cable
Access Cover
Zip Ties (2 each)
#8 Wood Screws
and washers
(4 each)
#6 Sheet Metal
Screws
(4 each)
#4 Sheet Metal
Screws
(2 each)
Screw Size and Type
(Number) and Function
#4-20 x 5/16" Sheet Metal
#8-15 x ¾" Wood
#6-19 x 3/8" Sheet Metal
(2) Secure rear cable access cover
(4) Secure SMB 1 to furniture
(4) Secure wall plate adapter to SMB 1
Mount the SMB 1 Directly to Furniture or a Wall
The illustrations in this section of the guide show the SMB 1 mounted to a table-top or lectern. Wall mounting is identical except
that the base of the SMB 1 is vertical, against the surface of the wall.
ATTENTION:
•
Four wood screws are provided to mount the SMB 1 to a table top. To mount the SMB 1 to a wall, use screws and
fixtures that are appropriate for the wall material. These are not provided.
•
All structural steps and electrical installation must be performed by qualified personnel in accordance with local and
national building codes and local and national electrical codes.
1.
Determine where the SMB 1 is to be mounted.
2.
Mark the position of the four mounting holes and drill four pilot
holes 3/32 inch (2.4 mm) in diameter into the tabletop or wall.
3.
If cable access is required through the base of the SMB 1,
remove the hole plug from the bottom cable access hole. Mark
the position of the hole and drill a hole through the table that is
large enough to carry the cables.
4.
Secure the SMB 1 to a table-top using the four provided
#8 wood screws with washers.
Mounting Holes (4)
#8 Wood Screws
with Washers (4)
Bottom Cable
Access Hole