Extron Electronics SMX System Setup Guide - Manual (Page 41)

35 SMX System MultiMatrix Switcher • Control and Configuration
Using the Web Pages to Configure the SMX
The SMX settings can be configured via LAN or WAN web pages using
a suitable Internet browser (Internet Explorer, Firefox
® ).
To view and configure the SMX via web pages:
1. If not already done, connect the SMX to a PC using the rear panel
RJ-45 LAN connector.
2. Open the Internet browser on the host computer, and in the
address bar, type the IP address for the SMX .
NOTE: The default IP address is 192.168.254.254. Check with
the administrator if the IP address has been changed.
3. The browser opens the SMX default web page (see figure 26 ), at
the System Status page.
Figure 26. SMX Default Web Page — System Status
There are three other pages: the Configuration page, the
File Management page, and the Control page. Any of these pages
can be accessed by clicking on the applicable tab.
Click in the left column to access related subsections of each page.
Status Page
This page allows the user to monitor the system. Settings shown are
not configurable from this page. The page may include subsections
such as System Status, Physical Configuration, and DSVP.