Extron Electronics Routing Template User Guide - Manual

Routing Template • User Guide
This guide provides instructions for an experienced installer to use the Extron routing templates to prepare furniture for mounting
the HSA and Cable Cubby products.
ATTENTION: Use the appropriate Extron routing template for your HSA or Cable Cubby model. See www.extron.com for
routing template part numbers and cut-out dimensions.
Tools and Equipment Required for Installation
Clamps (4)
Safety Glasses
1/2" Screws (4)
1/2" Router Bit
Screw Driver
Tape Measure
Router w/
5/8" Guide Bushing
Vacuum Cleaner
Square
Preparing the Routing Template
1. Cut two 1/2-inch x 4-inch strips of soft, finished
lumber. The strips should be long enough to span
the distance between the installation location and
the edges of the table (
a ).
2. Using four or more short screws, secure the
routing template to the lumber strips (
b ).
ATTENTION: Do not allow the screws to
protrude through the bottom of the strips.
Protruding screws will mar the table when
the template is used.
Preparing the Table
1. Mark the desired mounting location on the
tabletop (
a ).
ATTENTION: Make sure the mounting
location is oriented properly for the
intended user access side of the unit. The
user access side is labeled in the routing
templates.
2. Place the mounting template assembly on the
table and center it on the mounting location (
b ).
3. Once the template assembly is positioned,
secure it to the table with C-clamps (
c ).
TIP: For extra table protection, place a layer
of soft, thick cloth between the lumber
strips and the tabletop.
HSA 200 USER AC CESS
HSA 200 CABL E C UBBY 300
CABL E C UBBY 300
USER AC CESS
4 Screws Min.
Clamps (4) Sandwich Table
Between Soft Lumber
Routing Template
1
3
2
1/2 x 4 Soft,
Finished Lumber
a
b
HSA
200
USER A
CCESS
HSA 20
0
CABLE
CUBBY
300
CAB
LE CU
BBY 30
0
USE
R A C C E S S
1/2 x 4 Soft,
Finished Lumber
4 Screws Min.
Routing Area
Width of Mounting Surface