Extron Electronics RGB-DVI 300 Setup Guide - Manual

RGB-DVI 300 and RGB-HDMI 300 (A) Setup Guide
CAUTION: Installation and service must be performed by authorized personnel only.
Unless otherwise stated, these instructions apply to both the RGB-DVI 300 and the RGB-HDMI 300 (A) video scalers and
converters. These instructions provide a quick setup guide for experienced installers.
Step 1 — Power Off
Turn all the equipment off and disconnect all cables.
Step 2 — Mounting
Mount the unit in a convenient location, in a rack, behind a display, under a desk, or through a desk.
Step 3 — Connect Video and Audio Input
Connect an analog RGB or HDTV YUV video input to the 15-pin female VGA connector. Connect an analog audio source to
the 3.5 mm TRS connector (RGB-HDMI 300 A only).
Step 4 — Connect Display Device
Connect the unit to a digital display using a HDMI connector for the RGB-HDMI 300 (A) or a DVI-I connector for the
RGB-DVI 300.
NOTE: The RGB-DVI 300 only outputs a DVI-D signal, although a DVI-I connector is used for greater installation
flexibility.
A display is required to control the RGB-DVI 300 or RGB-HDMI 300 (A) using the menu and on-screen display.
Step 5 — Connect and Apply Power
Connect the 12 VDC external power supply (provided) to the 3.5 mm, two-pole, captive screw Power input connector. Apply
power to the RGB-DVI 300 or RGB-HDMI 300 (A) power supply. Then power on the display and power on the video source.
Step 6 — Configure System
Configure the system via the front panel controls and on-screen display, Simple Instruction Set ™ (SIS ™ ) commands, or
the Signal Processing Products Control Program. (See the RGB-DVI 300 and RGB-HDMI 300 (A) User Guide for complete
instructions.)
DVI-D OUTPUT
12V
1.0A MAX
POWER
RS-232
Tx Rx
RGB - DVI 300
RGB/ R-Y, Y, B-Y INPUT
RGB-HDMI 300 A
RGB-DVI 300
Front Panel
Front Panel
Rear Panel
Rear Panel
RGB - HDMI 300 A
MENU ENTER
ADJUST
CONFIG
12V
1.0A MAX
POWER
RS-232
Tx Rx
RGB - HDMI 300 A HDMI OUTPUT
INPUT
AUDIO RGB/R-Y,Y,B-Y
RGB - DVI 300
MENU ENTER
ADJUST
CONFIG