Extron Electronics TLP 700TV User Guide - Manual (Page 55)

Replacing Button Labels
The illustration below shows how to replace the button labels on the TLP 700MV.
Although, the buttons on the TLP 700TV are slightly smaller and the labels are different
dimensions, the procedure for replacing labels on either model is the same. To change the
translucent button labels for either model, follow these steps, as shown in the diagram:
TEXT
Pull the lens from the button
and add the label.
Button Label
Clear Lens
Figure 48. Removing Buttons
1. Pull off the clear plastic lens covering the button using the thumb and forefinger.
2. If necessary, remove the existing label; it may be inside the lens or the top of the
button plunger.
3. Place the new label inside the plastic lens. Ensure that the label and the lens are in the
correct orientation.
4. Align the plastic lens with the button plunger and firmly snap it into place.
5. Repeat steps 1 to 4, as needed, to relabel all the buttons.
TLP 700MV and TLP 700TV • Button Labels 49