Braun 5612 Flex XP - Manual (Page 6)

6
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a special cord
set/charging stand with integrated Safety
Extra Low Voltage power supply. Therefore
you must not exchange or manipulate any part
of it. Otherwise there is a risk of electric shock.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Release button
5 On/off switch
6 Long hair trimmer
7 Charging light
8 Special cord set (model 5665/5612)
Charging stand (model 5610)
Charging the shaver
• First charging: Using the special cord set/
the charging stand, connect the shaver to
an electrical outlet with the motor switched
off. Charge it for at least 4 hours (special
cord set and shaver might get warm). Once
the shaver is completely charged, shave
until fully discharged. Then recharge to full
capacity again (subsequent charges will
take about 1 hour).
• The charging light shows that the shaver is
being charged. Model 5665/5612 only: When
the rechargeable battery is fully charged,
the charging light goes off. If later on, the
light comes on again, this indicates that the
shaver is being recharged to maintain its full
capacity.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15 °C to 35 °C.
• Model 5665/5612 only: When fully
discharged, you may also shave with the
shaver connected to an electrical outlet via
the special cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Cleaning
This appliance is suitable for cleaning
under an open water tap.
Warning: Detach the hand-held part
from the power supply before cleaning it in
water.
Regular cleaning ensures better shaving
performance. Rinsing the shaving head after
each shave under running water is an easy
and fast way to keep it clean:
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace your foil and cutter block at least
every 18 months or when worn.
English
5720320_5665_MN Seite 6 Mittwoch, 15. März 2006 8:45 08