Extron Electronics UPB 25 Installation User Manual
Upb 25 • installation guide, Important safety instructions, Planning
1
Product Category
The UPB 25 is a versatile projector mount that works with most LCD/DLP
projectors weighing up to 25 pounds (11 kg) and accepts a 1.5-11.5 NPT/NPS
pipe. The flexibility of the UPB 25 allows for quick dismounting and
remounting of the projector to the support pipe.
The UPB 25 consists of two parts: the upper Adjuster Plate
a
, which mounts
onto the projector pipe, and the lower Projector Bracket
b
which attaches
directly to the projector. An assortment of mounting hardware is included.
PROPER MOUNTING PROCEDURES MUST BE
FOLLOWED.
UPB 25 • Installation Guide
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before starting installation.
When using this accessory, basic precautions should always be followed, including the following:
WARNING:
Risk of Personal Injury. Maximum projector weight for the UPB 25 is 25 lbs (11 kg).
SAVE THESE INSTRUCTIONS
NOTE: Refer to local building standards and codes to verify that the installation will meet the regulatory requirements.
Observe all local and national building and safety codes, UL requirements, and ADA accessibility guidelines.
a
Adjuster
Plate
Projector
Bracket
b
Planning
Before starting the installation:
Check the Projector
c
Weight — The UPB 25 can mount a projector with a maximum weight of 25 pounds (11 kg).
c
Mounting point location — Use all available mounting points (typically 3 or 4) on the projector base to securely
attach the projector.
c
Check the minimum and maximum throw distance of the projector. See the projector documentation for details.
Check the Mounting Location
It is important that you do the following:
c
Check the structural ceiling to ensure that it can support a load four times the total weight of the final setup.
Included Parts
Part
Qty.
Part
Qty.
UPB 25
1
Projector Bracket
1
Adjuster Plate
1
Mounting Screws (4 sets, 3-6 mm)
16
Washers (3 sets)
12
Adjustment Screws (10-32, ¾ inch)
4
Hex Wrench, 3/32 inch
1
Projector
Bracket
Adjuster
Plate