Extron Electronics TMK Series Installation - Manual

IMPO
RTAN
T:
Go to www
.extron.com
for the
complete user guide
, installation
instructions,
and specifications.
TMK Series • Installation Guide
The TMK series Table Mount Kits allow under-table installation for up to two single-space
AAPs (TMK 120 AAP) or up to three single-space AAPs (TMK 130 AAP). Both kits secure
to the underside of a table. The kits can also be mounted side-by-side for applications
requiring additional AAP spaces.
NOTE: The location must consider that cables are connected to the AAPs both from
the front and from the rear, and the bracket and AAPs must be readily visible to
prevent accidental contact.
ATTENTION: Do not drill through the table or furniture. If the table is too thin or of a
different material for the supplied screws, use an appropriate type and length.
US B CHA
RGE R
USB CH ARG ER
Tighten
Tighten
USB CH ARG ER
USB CH ARG ER
1
Install #6 x 1/2 inch wood screws
into the pilot holes.
Tighten until 1/4 inch protrudes.
Drill 3/32-inch (2.4 mm) diameter,
1/4 inch (6.3 mm) deep pilot
holes.
Mark the four keyhole locations at
the desired mounting location.
2
Slide the faceplate onto the screws.
Tighten the front keyhole screws only.
5
4
3
Connect the cables and wiring
to the AAPs.
7
6
8
Install the two sheet metal screws to
secure the faceplate and cover
together.
Tighten the two rear keyhole screws
through the openings in the cover.
9
Install AAPs in the faceplate.
(4)
Faceplate
Screws (2)
Slide the cover up and into the faceplate.
Make certain the rear slots of the cover
slide into the rear keyhole screws.
#4 x 1/4" (2)
Sheet Metal Screws
#6 x 1/2" (4)
Wood Screws
Cover Faceplate
Included Parts
Mount the TMK bracket as follows: