Extron Electronics Replacing Button Labels User Manual

Extron Electronics Hardware

Advertising

Extron Electronics, USA

1230 South Lewis Street

Anaheim, CA 92805

USA

714.491.1500

Fax 714.491.1517

Extron Electronics, Europe

Beeldschermweg 6C

3821 AH Amersfoort

The Netherlands

+31.33.453.4040

Fax +31.33.453.4050

Extron Electronics, Asia

135 Joo Seng Road, #04-01

PM Industrial Building

Singapore 368363

+65.6383.4400

Fax +65.6383.4664

Extron Electronics, Japan

Kyodo Building

16 Ichibancho

Chiyoda-ku, Tokyo 102-0082 Japan

+81.3.3511.7655

Fax +81.3.3511.7656

www.extron.com

68-1167-01

Rev. A

06 05

TEXT

Separate the two-
piece button here at
the corner.

Pry the two
pieces apart.

Diffuser

Plunger

Base

Button Label

Clear Lens

Notch

Pry the button
from the base.

Attention: This product is made with new high tension button caps.

Replacing Button Labels, cont’d

Replacing Button Labels

Follow these steps to relabel the button:
1.

Remove the button assembly from the device.

The button assembly consists of a clear lens cap, the label,

and a white diffuser. See the diagram on the opposite

side of this instruction card.

Insert a small, flat-bladed screwdriver, such as an

Extron Tweeker, between the button’s base

and the diffuser to gently pry the button assembly

off from the button plunger, as shown to the right.

Locate the small corner notch on the lens

cap and slide the screwdriver between the lens

cap and the diffuser. See illustration on the

opposite side of this instruction card.

Using a rotating motion of the screwdriver ( ),

carefully pry the two pieces apart.

Replace the label with the new button label.

Reverse steps 2 and 1 to reinstall the button to the product.