Extron Electronics WMK 150 - Manual

PRELIMINAR
Y
1
WMK 150 • Setup Guide
68-1903-01
Rev C
05 12
The Extron ® WMK 150 Wall Mount Kit is used for hanging WallVault ® System AV products on a wall near a flat
screen display or short throw projector.
The WMK 150 has an enclosure 15.5 x 13 x 2.75
inches, and a
base plate on which to mount the switcher, for example a
PVS 305SA, and the power supply, with room for cable
management. In addition, an accessory device can be mounted
on the base plate. The cover has knockouts on all four sides
that allow external raceways or conduit to be used where
needed for cabling.
WARNING:
Risk of Personal Injury. Maximum load for the
WMK 150 is 15 lbs (7 kg)
NOTE: The WMK 150 is to be used only with Extron UL
listed products.
The key components (base plate and cover) of the WMK 150 are
shown assembled in figure 1.
Included in the kit are:
(2) ¼-20 x 2" pan head bolts, (2) ¼" KapToggle ® assemblies, (4) #14 x 1¾" self tapping metal/wood screws,
(4) 6-32 x ¼" button head hex screws.
Not shown but included are (3) 4-40 x ¼" screws, (2) tie wraps (15"), (8) 4-40 x 3/16"
screws (used to attach other Extron devices), and the PVS switcher mounting plate.
Figure 1. WMK 150 parts
(4) #14 x 1 3/4"
Self-tapping
Metal/Wood Screws
#40-372-01
(2) 1/4-20 x 2"
Pan Head Bolts
#40-375-01
(2) 1/4" KapToggle ®
Assemblies
#40-374-01
(4) 6-32" x 1/4"
Button Head
Hex Screws
#40-363-17LF
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before using this furnishing.
When using this furnishing, basic precautions should always be followed, including the following:
DANGER: Risk of Electric Shock . Disconnect power to this furnishing before cleaning.
WARNING:
Risk of Electric Shock. Devices used in this furnishing should be connected to a properly grounded outlet
only. See Grounding Instructions in the device manual.
WARNING:
Risk of Personal Injury. Read and follow the steps below to reduce the risk of burns, fire, electric shock, or
injury to persons.
1. Always unplug devices installed in this furnishing from outlets before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended
by the manufacturer.
4. Never operate a device in this furnishing if it is not working properly, if it has been dropped or damaged, or dropped into
water. Return the device used in this furnishing to a service center for examination and repair.
5. Never operate the furnishing with the air openings blocked. Keep the air openings free of lint, hair, and the like.
6. Never drop or insert any object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9. To disconnect the devices, turn all controls to the off position, then remove plugs from outlet.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead
on the product