Extron Electronics SW RGBHV Series User Guide - Manual (Page 16)

2-5 SW RGBHV Series Switchers • Installation
Under Desk Kit
SW 2 R GB HV
RG BH V & AU DIO SW ITC HE R
AU TO SW ICH AC UT IVE
2
1
Figure 2-3 — Under-furniture mounting
SW4 and SW6 models
1 . Secure the optional table/wall mounting brackets to the switcher with the
eight #8 machine screws provided in the mounting kit (figure 2-2 on page 2-4).
2 . Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the underside of the
desk.
3 . Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4 . Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
5 . Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
6 . Slide the switcher slightly forward or back, then tighten all four screws to
fasten it in place.