Imetec DOLCEVITA CH5 - Manual (Page 7)

E
N
G
L
I
S
H
5
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES [Fig. Z]
a Motor unit c Stainless steel blade e Container
b Protection cover d Blade pin f Power cord
ON AND OFF CONTROL
The mini-chopper can be used in two ways
SAFETY SYSTEM FOR IMMEDIATE MOTOR SHUTDOWN
A safety system stops the appliance from functioning if the following accessory is not properly assembled:
- protection cover b.
MAXIMUM WORKING QUANTITIES AND TIMES
When using, make sure you do not put in more than 50g of raw meat or solid foods.
In particular, for very hard food, put smaller quantities of food in the container e and carry out the operation several times.
After 30 seconds of pulse action or continuous processing, leave the appliance to cool down for at least 2 minutes. After 5 continuous
processing cycles, leave it to cool down for at least 30 minutes.
G E N E R A L I N S T R U C T I O N S
FUNCTION USE
Pulse action
Ideal for mincing solid ingredients
(press and release)
Continuous action
Ideal for high speed processing
(keep pressed for the required time)
MINI-CHOPPER
- Fit the blade c onto the container’s pin d [Fig. A].
- Put the solid ingredients cut into small pieces in the container, distribute them evenly and make sure you don’t go over the maximum
level indicated.
- Put the plug in the socket.
- Fit the protection cover b in its seat inside the container [Fig. B].
- Place the motor unit on the container [Fig. C].
- Press down on the motor unit a and operate the appliance at continuous or pulse action depending on the processing that you wish
to carry out [Fig. D].
- Keep an eye on the mix and continue processing until you obtain the desired result.
- Release the motor unit a to turn off the appliance and wait until the blade c stops before lifting the motor unit a and the protection
cover b.
Please note:
- For safety reasons, you cannot use the appliance without correctly fitting the protection cover b.
CLEANING
- Disconnect the appliance plug from the socket.
- Clean the motor unit and the cord with a damp and well-wrung sponge.
- All the accessories can be washed:
- by hand: wash with water and detergent. Handle the stainless steel blades c with care to avoid getting cut or damaging the blades.
After washing, rinse and dry them thoroughly.
- in the dishwasher: make sure that the water does not exceed the maximum temperature of 60° C.
DISMANTLING
- Disconnect the appliance plug from the socket and follow the assembly sequence in exactly the opposite order, removing one piece
at a time.
Please note:
- Never immerse the motor unit a, cord f or plug in water.
- Do not use this appliance for processing frozen or raw meat, candied fruit, gummy sweets, cheese rind or non-edible parts
of food (e.g. bone, fish bone, fruit stones and pips, etc.).
- Do not use the appliance with liquids food only
U S E R I N S T R U C T I O N S