Imetec DOLCEVITA BL4 - Manual (Page 9)

7
GB
SAFETY SYSTEM FOR IMMEDIATE MOTOR SHUTDOWN
A safety system stops the appliance from functioning in the following cases:
•
if the glass jar is not correctly or properly seated in the motor unit
• if the glass jar is removed from the motor unit during operation
Please note:
Do not use the safety system as a way of starting or stopping the appliance instead of the Speed selector.
MAXIMUM WORKING QUANTITIES AND TIMES
When using, make sure you do not put in more than 800 ml of ingredients.
In particular, for processing hard food, put smaller quantities of solid ingredients and a large percentage of
liquid ingredients in the jar (2) and carry out the operation several times.
After one minute of continuous processing, leave the appliance to cool down for a few minutes.
Please note:
Avoid using the appliance with only solid ingredients.
USER INSTRUCTIONS
FIRST USE
•
Make sure the appliance is not plugged in.
• CAUTION: Make sure the ring nut (6c) is fi rmly screwed onto the jar. If not, it may cause liquid leakage
during the use.
• Slide the assembled jar into the motor unit (3) following the interlocking slot [Fig. C].
BLENDING
WARNING: Do not operate the appliance without ingredients.
•
Put the liquid and solid ingredients into the jar without going over the maximum level indicated.
• Cover the jar (2) tightly with the lid (1). The lid (1) must always be in place when the appliance is in
operation. The hole on the lid can be useful to add liquid ingredients during the use.
• Plug in the appliance.
• Start the blender by setting the speed selector (5) to the desired speed position (1/2/P).
• To stop the appliance, turn the selector (5) back to position “0”.
• ALWAYS turn the blender off (set the speed selector (5) to position “0”) and wait until the blades (6a)
have stopped rotating before removing the jar (2).
• To remove jar (2) after blending is complete, lift the jar (2) straight up. Do not twist.
DISMANTLING
•
Disconnect the appliance plug (4) from the socket.
• Lift the glass jar (2) from the motor unit (3).
• Unscrew the ring nut (6c).
• Remove the blades (6a) and the gasket (6b) from the glass jar (2).