Imetec ECO E1 - Manual (Page 13)

EN
11
Ʒ Always use the appliance with a motor protection filter to prevent damaging the
motor and the vacuum cleaner.
Ʒ The power cable must always be fully unwound to prevent hazardous
overheating.
SYMBOLS
Protection class II ON/OFF switch
Automatic cord winding Prohibited
Carpets and rugs Hard floors
DESCRIPTION OF THE APPLIANCE AND ACCESSORIES (Fig. A)
Refer to Figure [A] in the illustrative guide to verify your appliance equipment. All the figures
are on the cover pages of these instructions for use
1. Handle
2. Air flow manual adjustment device
3. Suction pipe
3A. Adjustable telescopic pipe
ʺƔ»В»Й¹ЕЖ¿¹Ж¿Ж»·ºÀËÉÊûДК¸ЛККЕД
4. Combination carpet/floor brush
ʻƔИЛЙ¾ЖЕЙ¿К¿ЕДКЕ½½В»ЙН¿К¹¾
5. Flexible suction pipe
6. Flexible suction pipe fastening button
7. Discharge filter grid
8. Electronic power control
9. ON/OFF switch
10. Automatic cable winding
11. Dust collection system handle
12. Handle
13. Suction inlet
14. Power cable with plug
15. Dust collection system
15A. Dust container
ʸʼƔЕН»И¹ЕМ»ИЕЖ»Д¿Д½Б»П
15C. Lower cover
15D. Cyclone filter
15E. Hepa filter
15F. Sponge filter
16. Outlet filter
17.
·ИБ¿Д½ЖЕЙ¿К¿ЕД
17A. Horizontal
ʸʾƔ»ИК¿¹·В
18. Accessories
18A. Crevice tool
ʸʿƔЛЙК¿Д½ДЕРРВ»
18C. Upholstery nozzle
18D. Parquet brush
19. Accessory-holder on the telescopic pipe
20. SPT (System Protection Technology SPT)
LED Indicator
ATTENTION! The vacuum cleaner has a motor protection thermostat,
which intervenes in the case of overheating (caused by the inlet opening,
filters, etc. being clogged). If it is triggered, press the ON/OFF button
to switch the appliance off and let it cool down for a few hours. Verify
whether dust has clogged the filters or the inlet opening before restarting
the appliance.