Imetec RELAXY INTELLISENSE MATRESS COVER DOUBLE DUAL - Manual (Page 11)

IT
9
MACHINE wASHING
• The electric blanket can be machine washed at 40°C using a delicate program.
• Only the gentle spin cycle is to be used. Do NOT program an extra spin cycle.
wASHING BY HAND
• The electric blanket can be washed by hand at a maximum temperature of 40°C.
• Use a liquid soap for delicate garments (read the product dosage instructions).
DRYING
• Set the dryer at a low temperature.
• Hang the electric blanket without applying pegs on the electrical parts so as not to damage them.
•
Do NOT use the electric blanket until it is completely dry.
HANGING THE ELECTRIC BLANKET TO DRY
• The electric blanket must be hung to dry in the approximate original dimensions. The best results are obtained when it is still damp, pulling a
panel at a time from one end and the other. This may have to be repeated a number of times until the electric blanket is completely dry.
• Make sure the wires are not kinked or twisted. It is easier to check the wires by placing the electric blanket against the light.
• If problems arise with the wires after having hung the electric blanket or if it does not return to its original size, return it to an authorised Imetec
Service Centre for a safety check.
STORING THE ELECTRIC BLANKET
aTTEnTIon! When you store the appliance, let it cool down before folding it.
IMpoRTanT!
When you store the appliance, do noT place objects on top of it which crease it and/or deform it.
The fabric may take on a natural yellow colour over time. This does not compromise the safety and/or performance of the product in
any way.
TROUBLESHOOTING
This chapter describes the most common problems related to appliance use. If the problems cannot be resolved with the information below, please
contact the Authorised Assistance Centre.
problem solution
The light of the control
unit does not go on
Check whether the plug of the control unit is inserted correctly and the instructions to switch the electric
blanket on have been followed correctly.
Verify whether the plug is inserted correctly into the socket and if the power is on.
Check whether the timer selector (5) is set to 1 or 9 hours and whether the LED is flashing. If so, repeat
the steps in the “SWITCHING THE ELECTRIC BLANKET ON AND SELECTING THE CORRECT
TEMPERATURE” chapter.
Check whether the switch-on selector is set to “ON” ( )
The appliance must only be checked by an authorised technical service centre in order to prevent any risk.
A tingling sensation is felt
when using the appliance.
Disconnect the plug from the socket and reconnect it by inverting the polarity.
Mark the entry side for future use.
The stand-by display light
flashes
Check that the connector of the electric blanket is inserted correctly and completely.
EN
MI000051_multi.indd 9 29/05/12 16.55