Unibor UA5000 Autofeed - Manual (Page 6)

10 11
W ARNING - S WITCH OFF AND REMOVE
POWER PLUG FROM THE SUPPLY DURING
MAINTENANCE AND INSPECTION
C AUTION - C HECK ALL PARTS
REGULARLY AND TIGHTEN ANY LOOSE
SCREWS .
• Occasionally apply a few drops of oil to the
rack teeth.
• The bearings of the feed shaft are self-
lubricating and must not be greased
• Grease the sliding surface of the cradle with
MOLYCOTE grease.
• The arbor support bracket is of key importance
for accurate drilling, it is held in place by 3 socket
head cap screws which should be regularly
checked for tightness.
• When not in use or drilling is suspended,
the cradle should be prevented from moving
downward by tightening the cradle locking set
screw.
• When being transported, the unit should be
kept in the case supplied.
• After use ensure unit is clean of swarf & dirt.
• Parts that are worn or damaged should be
replaced immediately with genuine Universal
Drilling replacements.
• Ensure all cutting edges are sharp when in
operation. Using blunt cutting tools may lead to
an overload or lock up of the motor, shattering
of the cutter or longer cutting times. Cutters can
be re-sharpened, contact your distributor for
details.
• Ensure the pilot pin is sharp, if not it may not
locate precisely in the punch hole, leading to
inaccurate hole positioning. The pilot should be
replaced or sharpened.
M
AINTENANCE
• After repeated use, the cradle may become
loose. This is remedied by adjusting the tension
screws on the side of the body. Put a 3mm allen
key into head of the cradle retaining nuts, and
using 10mm Spanner undo the locking nuts anti-
clockwise holding the Allen key without moving
grub screws.
Using the allen key gently tighten screws in series
until the cradle moves freely in the slide but does
not let the motor to fall under its dead weight or
allow the motor to wobble.
When adjustment is complete re-tighten locking
nuts clockwise.
E U D ECLARATION OF C ONFORMITY
EC Declaration of Conformity
Certificate No. EC/MT
We hereby certify that the machine described below:-
1. TYPE : Electro Magnetic Drilling Machine
2. MODEL No: .............................................................
3. SERIAL No: .............................................................
These power tools have been designed in compliance with:
98/37/EEC, 89/336/EEC, 73/23/EEC, EN 55014-1, EN 55014-2,
EN 55022, EN 61029, EN 61000-3-2 & EN 61000-3-3.
and with the essential Health & Safety requirements.
Signed: ............................................................. Y. Kasuya (Director)
RECYCLING
Do not dispose
of electrical
equipment together
with household
waste material!
In observance of European Directive
2002/96/EC on waste electrical and
electronic equipment and its implementation
in accordance with national law, electric
equipment that has reached the end of
its life must be collected separately and
returned to an environmentally compatible
recycling facility.
WEEE Compliance Certificate No. XXXXX
All magnetic drilling systems are fully
compliant with ROHS regulations