Ultimate Support GS-100 - Manual (Page 2)

STEP 1
Turn stand upside-down and locate the
RED / GRAY Locking Knob. Turn the Locking
Knob ¼ turn counterclockwise to the open
position shown above.
STEP 5
Flip open the RED / GRAY telescoping Lock
Lever at the back of the stand. Adjust
the height of the stand until your guitar’s
bottom edge or instrument cable is about
2 inches from the floor. Flip down the Lock
Lever to set the height.
2 3
STEP 2
Turn the stand back to the upright position
and fold all three legs down until they
stop in the open position. (The legs should
move freely to the open position, if they do
not, make sure the Locking Knob is in the
open position.)
STEP 6 for GS-100 (#13710)
Unhook the Retention Strap from the open
position and pull strap around to the front
of the yoke. Stretch the strap over the
other end of the yoke to secure guitar.
STEP 3
After all three legs are in the open position
turn the RED / GRAY Locking Knob ¼ turn
clockwise to the closed position
shown above.
STEP 6 for GS-1000 (#16538)
Place guitar or bass into the stand and
the instrument’s weight pulls the yoke
closed around the headstock. To remove
the instrument, simply lift up to release the
security gate.
STEP 4
Rotate the Neck Yoke to the open position
shown above. The yoke should firmly snap
into position.
STEP 7 OPTIONAL: On GS-100
Convenient guitar pick storage slots are
located along the top of the yoke.
LOCKING
KNOB
OPEN OPEN CLOSED CLOSED
LOCKING
KNOB
1
5
2
6
3
6
4
7
set-up