ProTeam ProGuard LI 3 Cordless - Manual (Page 11)

ProTeam 11
Emptying the Dust Drum
Blowing Feature
Your Wet/Dry Vacuum has the capability
to blow sawdust and other debris and to
be used as a blower for yard work, patio
cleanup and workshop applications.
NOTE: The blowing port is located
opposite the vacuum port.
WARNING - Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before using
as a blower.
WARNING - To reduce the risk of injury to bystanders, keep them clear of
blowing debris.
CAUTION - Wear a dust mask if blowing creates dust which might be inhaled.
(Use N95 or P100 masks when using the vacuum as a blower.)
CAUTION - To reduce the risk of hearing damage, wear ear protectors when using
the Vacuum/Blower for extended time or in a noisy area.
OPERATION
(Continued)
Power
Head
Latch (one
on each
side)
PULL LATCH OUT
FROM THE TOP
AND UP FROM
THE BOTTOM
Figure G
Figure H
1. To remove the lid to empty contents
of the dust drum, simply lift the
two drum latches on the side of the
Vacuum and lift the power head up
and off the dust drum and set to the
side
WARNING - To reduce the risk
of injury from accidental starting,
remove battery before emptying the
drum.
2. Lay the power head on a clean dry
area while emptying the drum or
changing the filter.
3. Dump the drum contents into the
proper waste disposal container
!
!
!
!
!