ProTeam ProGuard Front Mount Squeegee - Manual (Page 4)

4 ProTeam Front Mount Squeegee
ASSEMBLY
Release
Pedal
Wheels Removed for Clarity
Pedal Latch
Mounting
Bracket
Squeegee
Pivot Plate
3. Place the squeegee pivot plate inside
the mounting bracket with the pedal of
the squeegee pivot plate at the back of
the cart (as shown in Figure C).
4. Place the 3/8” bolt through pivot
plate and adjust the bracket front
to back (if needed) so pedal latches
properly (Figure C). Remove the 3/8”
bolt and squeegee pivot plate and
tighten the two 5/8” bolts holding
the squeegee mounting bracket in its
proper position. Repeat Steps 3 and 4
if needed for proper pedal alignment.
Spring
Wire Tie
Thumb Screw
Figure D
5. With the squeegee pivot plate
removed, hook the spring into the
thumb screw (provided in base).
6. Secure the wire tie in a loop and hook
it to the spring as shown (Figure D).
Squeegee
Pivot Plate
Mounting
Bracket
Figure E
7. Place the squeegee pivot plate inside
the mounting bracket with the pedal of
the squeegee pivot plate at the back of
the cart (as shown in Figure E).
Pin
Figure F
8. Feed the wire tie and spring though
the opening in the pivot plate.
9. Using the wire tie, stretch the spring
and place the pin through the spring
into the slots as shown (Figure F).
Remove the wire tie after installation
of pin.