Braun 7540 Syncro EU - Manual (Page 8)

8
Keeping your shaver in top shape
Automated cleaning
The Braun Clean&Charge (only with model 7546)
automatically takes care of all cleaning and lubrication
needs of your shaver. Please refer to the separate use
instructions.
Manual cleaning
For easy cleaning after each shave, switch the shaver
off. Press the release buttons to lift the shaver foil
(do not remove the foil completely). Switch on the shaver
for approx. 5-10 seconds so that the shaved stubbles can
fall out.
For a thorough cleaning (weekly), remove the shaver
foil and tap it out on a flat surface. Using the brush,
clean the cutter block and the inner area of the pivoting
head. About every four weeks, clean the cutter block
with Braun cleaning agents.
If your skin is very dry and you notice a reduced operation
time of the shaver, apply a drop of light machine oil onto
the shaver foil.
Do not rinse the shaver in or under water.
Replacing the shaving parts
The shaver foil and cutter block are precision parts that,
in time, are subject to wear. Replace your foil and cutter
block every 18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. 7000)
(* Overall evaluation from Braun users comparing their
shave with new parts and those used for 18 months.)
Preserving the cell unit
• In order to maintain the optimum capacity of the cell unit,
the shaver has to be fully discharged (by shaving) every
6 months approximately. Then recharge the shaver to
full capacity again. This reconditions the cell unit.
• Do not expose the shaver to temperatures of more than
122 °F / 50 °C for longer periods of time.
oil
10
10
7000
7000
Syncro
5492451_S 4-26 Seite 8 Freitag, 31. März 2000 12:54 12