Andrew James AJ000148 Luggage Scales - Manual (Page 3)

3
Weighing
1. Strap the webbing belt through the luggage handle, and secure the hook of
the belt onto the triangular ring.
2. Press to switch on the scale before lifting the luggage (ensure that
there is no stress).
3. When the display shows zero, press UNIT to select the weight unit.
4. To re-weigh: press Z/T to reset the LCD display to zero.
5. Lift the scale gently. Make sure the scale is horizontal and balanced. LCD
shows the weight of luggage. Once the weight reading has stabilized, the
reading will lock. Scale will display weight reading for 2 minutes and
automatically switch off.
6. When the weight reading is locked, press Z/T to reset LCD display to zero
and start the process again. The Scale will automatically switch off when it is
left idle for 1 minute.
Room temperature

Press to switch on the device, wait until LCD shows zero. Press UNIT to
view the temperature (in Celsius and Fahrenheit). Press UNIT again to revert
the normal weighing mode.
To replace batteries
LCD will display ”Lo” when the battery power is low . Replace battery as follows:
1. Hold the scale in one hand. With the thumb and index finger of the other
hand hold and press on the screw threads of the battery case and pull out
the battery case from the slot.
2. Push corner A outwards to release the battery.
3. To insert a new battery, slide one side of the new battery beneath the
retainer notch B&C. Press the other side of the battery until it clips
underneath the corner A. Ensure to observe the polarity as illustrated in the
appliance components diagram.
4. Insert the battery case back into the slot on the scale.