Andrew James AJ000268 Patio Heater - Manual (Page 9)

9
9. Screw the cord of the appliance into the base of the appliance using the
fittings provided.
10. Plug the appliances electrical cord into the power supply, switch the
appliance on and select one of the three heat settings.
Operating the appliance

Connect the power cable to a 13 amp supply that is located in a safe, dry
area.

The switch on the heater head is used to control the three heat setting.
(I) = 900W
(II) = 1200W
(I & II) = 2100W

Although the patio heater is shower proof, do not use the patio heater when
it is raining or in wet conditions.

Always disconnect the power cable from the electrical supply, when the
patio heater is not in use.
Care and maintenance

When disconnected from the electrical supply, clean the outside of the patio
heater with a damp cloth. Never use corrosive or solvent cleaners or
immerse the appliance in water.

Any maintenance or repairs including replacing the halogen tube should only
be carried out by a qualified electrician or by a recommended service centre.

Once the appliance has been used , clean the appliance and store in a dry,
safe area. Cover the appliance after use to prevent the appliance from
rusting.

Do not store the appliance outside as this may cause the appliance to rust.