Andrew James AJ000472 16 Hole Shoe Organiser Rack - Manual (Page 2)

2
Components list

Square panels x 16

Side panels x 40

Connector discs x 48

Assembly instructions

To begin, place one of the 16 square panels on the floor. This will form the
back of your shoe organiser, once it is brought to its upright position.

Slide a connector disc onto each corner of the square, ensuring that the cross
shaped slot is facing upwards. (Each connector disc has four right angled
hollows between the smooth side and the cross shaped side where the
corners of the square panel slot in).

Connect another square panel alongside the original square panel by sliding
it into the remaining hollows in the connector discs.

Add more connector discs and square panels until you have achieved the
shape you require, remembering that the shoe organiser is lying down and
these squares will form the back once it is brought upright.

Once you have assembled the back of the shoe organiser, you can insert the
side panels to divide the shoe organiser by pushing them down into the
upwards-facing cross-shaped slots in the connector discs

Once you have added all the side panels you can secure the panels in place
by clipping the remaining connector discs onto the corners of each box you
have formed—this time the cross shaped slots will be facing inwards.

When you have finished, lift the shoe organiser into its upright position.
Apply pressure to all the joints ensuring all the panels are clicked into place
and to correct any misshaping.
Caution
It is advised to wear safety gloves when assembling the appliance.