Andrew James AJ000585 Blower Vacuum User Manual
Page 9
9
Preparing the Leaf blower prior to use
The leaf blower vacuum requires some assembly prior to first time use. This
includes the fitting of the blow/vac tube to the housing, the fitting of the collection
bag and the fitting of the wheel.
Assembly of the tubes (Fig. A)
1.
Insert the middle tube (13) into the front tube (12) aligning the screw hole in
the middle tube.
2.
Place a screw in the screw hole on the middle tube and tighten with a
screwdriver until secure.
Assembly of the wheel bracket
1.
Insert the wheel bracket from the lower end tube until it reaches the rib and
cannot move any further.
2.
Place a clutch screw into the screw hole on the wheel bracket. This can be
tightened using a normal 5mm flat head screw driver.
3.
Tighten the screw firmly.
Screw
Driver