Braun HC50 Hair Clipper Hair Perfect - Manual (Page 9)

9
Charging the clipper (HC 50 only)
When charging for the first time or when the appliance is not used for a few
months, leave the appliance to charge continuously for 4 hours.
The charging light shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged. Once the clipper is completely charged, use it without the cord
until discharged. Then recharge to full capacity again (1 hour).
A full charge will give up to 30 minutes of cordless trimming depending on
your hair. However, the maximum capacity will only be reached after
several charging/discharging cycles.
Best environmental temperature range for charging is 15 °C to 35 °C.
If the rechargeable battery is discharged, you may also operate the clipper
via the mains cord. (If the clipper does not run immediately, charge it for
approx. 1 minute in the «off» position.)
General
The person whose hair you want to cut should sit in a position where the
top of the head is at your eye level.
The hair should be clean, well combed, tangle-free and dry.
Ensure you have a firm, but relaxed grip on the clipper.
If you are not used to clipping hair, begin with a higher setting and then
reduce the setting to avoid cutting more hair than desired.
Use a slow and controlled movement. Do not force the clipper through
the hair faster than the clipper can cut it.
In between, shake or blow off the hair from the clipper. If too much hair
is caught in the distance comb, remove and clean it.
To control your progress during clipping, regularly comb the hair in the
style desired.
Normal clipping
Push the distance comb (1) onto the hair clipper until it locks. The hair
length selector (5) must be in position «1».
To choose the desired length setting (4), push down the length selector and
shift it upward. To start clipping, shift the on/off switch (6) to «on».
99405929_HC50_HC20 Seite 9 Donnerstag, 17. Dezember 2009 11:14 11