Braun 550cc-4 Series 5 - Manual (Page 10)

10
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
Shaver.
Warning
Your shaving system is provided with a
special cord set, which has an integrated
Safety Extra Low Voltage power supply. Do
not exchange or tamper with any part of it,
otherwise there is risk of an electric shock.
This appliance is not intended for use by
children or persons with reduced physical,
sensory or mental capabilities, unless they
are given supervision by a person responsible
for their safety. In general, we recommend
that you keep the appliance out of reach of
children. Children should be supervised to
ensure that they do not play with the
appliance.
To prevent the cleaning fluid from leaking,
ensure that the Clean&Renew station is
placed on a flat surface. When a cleaning
cartridge is installed, do not tip, move
suddenly or transport the station in any
way as cleaning fluid might spill out of the
cartridge. Do not place the station inside a
mirror cabinet, nor place it on a polished or
lacquered surface.
The cleaning cartridge contains a highly
flammable liquid so keep it away from
sources of ignition. Do not expose to direct
sunlight and cigarette smoking nor store it
over a radiator.
Do not refill the cartridge and use only
original Braun refill cartridges.
Description
Clean&Renew station
1 Level indicator
2 Lift button for cartridge exchange
3 Station-to-shaver contacts
4 Start button
5 Station power socket
6 Cleaning cartridge
Shaver
7 Shaver foil
8 Cutter block
9 Foil release buttons
10 Long hair trimmer
11 Comfort setting switch «sensitive»
12 Shaver-to-station contacts
13 On/off switch
14 Shaver display
15 Cleaning light (yellow)
16 Replacement light for shaving parts
17 Shaver power socket
18 Special cord set
19 Etui
A Before shaving
Prior to first use, you have to connect the
shaver to an electrical outlet using the special
cord set (18) or alternatively, proceed as
follows:
Installing the Clean&Renew station
• Using the special cord set (18), connect
the station power socket (5) to an electrical
outlet.
• Press the lift button (2) to open the housing.
• Hold the cleaning cartridge (6) down on a
flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the
station as far as it will go.
• Slowly close the housing by pushing it
down until it locks.
Charging the shaver in the Clean&Renew
station
Insert the shaver head down into the cleaning
station. (The contacts (12) on the back of the
shaver will align with the contacts (3) in the
cleaning station).
If required, the Clean&Renew station will start
charging the shaver now.
A full charge provides up to 45 minutes of
cordless shaving time. This may vary
according to your beard growth.
English
92274187_ContourX_Pro_S6-80.indd 10 03.04.12 08:57