Clock/alarm, Setting the clock and alarm – Arcam Solo Movie 5.1 User Manual

Page 26

Advertising

��

��

��

��

��

��

��

��

��

��

clock/alarm

Setting the clock and alarm

When Solo Movie 5.1 is in stand-by, press

MeNU

to set the clock or alarms.

Use the left and right buttons on the remote control to select the item to change, then
use the up and down buttons to change the value. For example, after pressing

MeNU

enter the clock/alarm setting menu, pressing up and down will change between setting the
clock and setting one of the alarms.
Solo Movie 5.1 allows up to four different alarms to be set.

Stopping or pausing an alarm

To stop an alarm ringing, press the power button on the front-panel or remote control.
Alternatively, press

to enter ‘snooze’ mode; the alarm will re-sound after a 10-minute

delay. Please note that you must be in

AMP

DVD

TUN

mode on the CR100 to

stop or pause an alarm from the remote control. To cancel snooze-mode, press the
power button.

Sleep timer

This timer allows you to specify a listening period, after which Solo
switches automatically into stand-by. The period can be set in
5-minute intervals, up to 120 minutes (2 hours): a count-down
timer is displayed on the front panel. To set the sleep timer,
press the

MeNU

key on the front panel (or

AMP

then

MeNU

key on the remote control) to access the

Amplifier menu (see page 14).

Alarms

Remember to set the time-of-day on the clock,
otherwise alarms and countdown sleep timers
will not work!

Retaining clock settings

If Solo Movie 5.1 is turned off at the mains supply,
clock settings are retained for approximately four
days. In the low power consumption ‘hard stand-
by’ mode, clock settings are retained indefinitely
(see page 21).

Advertising

Popular Brands

Popular manuals