AAEON GENE-5315 - Manual (Page 35)

S u b C o m p a c t B o a r d G E N E - 5 3 1 5
Chapter 2 Quick Installation Guide 2 - 22
Geode’s architecture limitation. The following steps for setup
the resources manually for your reference.
1. Retrieve the resource of the PC/104 card. The
information is typically contained in the manual of the
PC/104 card.
2. Push a function key “Delete” to get into the BIOS.
3. Enable the resource of the device in BIOS setup.
4. Disable the resource of the device for which conflicts
the resource of the device mentioned above in BIOS
setup.
5. Save above BIOS setup and restart system.
6. Install the driver in operating system.
7. Open your Control Panel (click Start, then pick
Settings then Control Panel). Double click the System
icon and choose the Device Manager tab. Find the
device for which you want to enable the device. Click
the plus sign (+) next to the various categories click on
the device you want to update, and then click on
"Resource" and then choose the resource what should
same as the hardware setup.
2.24 TTL LCD (CN12)
For 24-bit TFT LCD
Pin Signal Pin Signal
1 +5Volt. 2 +5Volt.
3 Ground 4 Ground
5 +3.3Volt. 6 +3.3Volt.
7 N.C. 8 Ground
9 B0 10 B1
11 B2 12 B3
13 B4 14 B5
15 B6 16 B7
17 G0 18 G1
19 G2 20 G3
21 G4 22 G5
23 G6 24 G7