AAEON EMB-B75B - Manual (Page 43)

Chapter 3: BIOS setup 3-11
3.4.2 System Agent (SA) Configuration
Graphics Configuration
Allows you to configure the graphics settings.
Primary Display [Auto]
Select which graphics device would be used as primary display.
Configuration options: [Auto] [IGFX] [PEG] [PCI]
Internal Graphics [Auto]
Configure IGD support for display. Configuration options: [Auto] [Disabled] [Enabled]
DVMT Pre-Allocated [64M]
Select DVMT 5.0 Pre-Allocated graphics memory size used by the Internal Graphics
Device. Configuration options: [32M, 64M, 96M ~ 1024M]
DVMT Total Gfx Mem [MEM]
Select DVMT 5.0 total graphics memory size used by the Internal Graphics Device.
Configuration options: [128M] [256M] [MAX]
Primary IGFX Boot Display [VBIOS Default]
Select which video device will be activated during POST. This setting does not apply
if external graphics hardware is available. VGA support only available on the primary
display.
Configuration options: [VBIOS Default] [CRT] [LVDS1] [HDMI1] [HDMI2]
Secondary IGFX Boot Display [LVDS1]
A secondary display will appear based on your selection. Configuration options:
[Disabled] [CRT] [LVDS1] [HDMI1] [HDMI2]
Select LCD Panel Type [1024x768, 18bit, 60Hz]
Select LCD panel type used by the Internal Graphics Device. Select the appropriate
resolution, bit rate, and refresh rate for your LCD panel.
LVDS Backlight Level [80%]
Select backlight brightness of LVDS. Configuration options: [100%~0%]
LVDS Backlight Type [Normal]
Select backlight control type. Configuration options: [Normal] [Inverted]
NB PCIe Configuration
Allows you to configure the NB PCI Express settings.
PEG0 - Gen X [Auto]
Configure PEG0 device. Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
Enable PEG [Enabled]
Enable or disble PEG support. Configuration options: [Disabled] [Enabled] [Auto]
Detect Non-Compliance Device [Disabled]
Detect non-compliant PCI Express hardware in PEG.
Configuration options: [Enabled] [Disabled]