AAEON IMBM-H61A - Manual (Page 42)

3-12 IMBM-H61A
Serial Port 3~9 [Enabled]
Allows you to enable or disable serial ports (COM) 3~9. Configuration options:
[Enabled] [Disabled]
RS Mode [RS232]
Allows you to configure the serial communications standard of serial port (COM) 9.
Configuration options: [RS232] [RS422] [RS485]
Serial Port 10~13 [Enabled]
Allows you to enable or disable serial ports (COM) 10~13. Configuration options:
[Enabled] [Disabled]
Parallel Port [Enabled]
Allows you to enable or disable the parallel port (LPT). Configuration options: [Enabled]
[Disabled]
Change Settings [Auto]
Allows you to select the Parallel Port base address. Configuration options: [Auto] [IO=378h;
IRQ=5] [IO=378h; IRQ=5,6,7,9,10,11,12] [IO=278h; IRQ=5,6,7,9,10,11,12] [IO=3BCh;
IRQ=5,6,7,9,10,11,12]
Device Mode [STD Printer Mode]
Allows you to set the Printer port mode. Configuration options: [STD Printer Mode] [SPP
Mode] [EPP-1.9 and SPP Mode] [EPP-1.7 and SPP Mode]
3.4.9 APM
Restore AC Power Loss [Power Off]
[Power On]
The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system
state was before the AC power loss.
Power On By PCIE/PCI [Disabled]
[Disabled]
Disables the PCIE/PCI devices to generate a wake event.
[Enabled] Enables the PCIE/PCI devices to generate a wake event.
Power On By Ring [Disabled]
[Disabled]
Disables Ring to generate a wake event.
[Enabled] Enables Ring to generate a wake event.
Power On By RTC [Disabled]
[Disabled]
Disables RTC to generate a wake event.
[Enabled] When set to [Enabled], the items RTC Alarm Date (Days) and
Hour/Minute/Second will become user-configurable with set
values.