AAEON RTC-1000i - Manual (Page 32)

R u g g e d T a b l e t C o m p u t e r R T C - 1 0 0 0 i
Chapter 2 Getting Started 2 - 13
Inserting a Memory Card
1. Hold the memory card by its edges with the edge-connector
side towards the slot.
2. Hold the card at a shallow angle (about 25 degrees) and insert
the edge connector into the connector slot (3). The “gold teeth”
of the edge connector should no longer be visible when the
card is fully inserted.
3. Press the card downwards so that it is flat inside the
compartment (4). You may hear an audible click as the latches
of the connector lock the card in place.
4. Replace GPS module, attach harness and secure it with
screws.
5. Replace the RAM compartment cover and secure it with the two
screws.
Your RTC will automatically detect the change in RAM capacity
when it restarts.
3
4