AAEON FSB-G41H - Manual (Page 62)

F u l l - s i z e S B C F S B - G 4 1 H
Chapter 4 Driver Installation 4-4
The following details the installation of the drivers while installing
Windows XP/ 2000.
1. When you start installing Windows XP and older operating
systems, you may encounter a message stating, “Setup could
not determine the type of one or more mass storage devices
installed in your system”. If this is the case, then you are
already in the right place and are ready to supply the driver. If
this is not the case, then press F6 when prompted at the
beginning of Windows setup.
2. Press the “S” key to select “Specify Additional Device”.
3. You should be prompted to insert a floppy disk containing the
Intel
®
RAID driver into the A: drive.
Note: For Windows Vista you can use Floppy, CD/DVD or USB.
-----------------------------------------------------------------------------------------
Important
Please follow the instruction below to make an “Intel
®
RAID Driver”
for yourself.
1. Insert the AAEON CD into the CD-ROM drive
2. Click the “Browse CD” on the Setup screen
3. Copy all the contents in \\Step4 - RAID\F6 Install
Floppy\32bit or 64bit to a formatted floppy diskette
4. The driver diskette for Intel
®
ICH10DO RAID Controller is
done
-----------------------------------------------------------------------------------------
For Windows Vista:
1. During the Operating system installation, after selecting the
location to install Vista click on “Load Driver” button to install a
third party SCSI or RAID driver.