Document Outline

• AEC-6860 Preface-0617.pdf
  • Copyright Notice
  • Safety & Warranty
• AEC-6860 Ch1-0611.pdf
  • General
  • New Innovation for Entertainment Multimedia Domain
    • System
      • Mechanical and Environmental
• AEC-6860 Ch2- 0617.pdf
  • Pin
    • Step 1: Take off the lid from the bottom of the chassis by loosening the screws.
  • CD-ROM and 2.5” HDD Kit Combination
    • Step 1: Get the disk bracket ready.
    • Step 2: Fasten the CD-ROM to the disk bracket with screws.
    • Step 3: Fasten the Riser Card and the CD-ROM with screws.
    • Step 4: Fasten the 2.5” HDD module to the disk bracket with screws.
    • Step 5: Insert the SATA cable and IDE cable into the slots on the Riser Card and the 2.5” HDD module.
    • Step 6: Place the CD-ROM and HDD kit into the suitable plate and then reverse it. Screw the CD-ROM and HDD kit to the plate.
  • Cable Insertion
    • Step 1: Open the HDD cover by loosening the screws on the bottom of the chassis.
    • Step 2: Insert the other side of IDE cable into the slot on the bottom of the chassis.
    • Step 3: Combine the chassis with the CD-ROM and 2.5” HDD kit plate. Then lock with screws.
  • HDD Kit Combination
    • Step 1: Get the bracket ready. Attach the rubber shock absorbers with the bracket as illustration shown below.
    • Step 2: Fasten the first HDD module to the bracket with screws.
    • Step 3: Fasten the second HDD module to the bracket with screws.
    • Step 4: Insert the HDD cable into the slot on the HDD module.
    • Step 5: Place the HDD kit into the HDD kit housing and then screw the HDD kit onto the HDD kit housing.
  • Cable Insertion
    • Step 1: Open the HDD cover by loosening the screws on the bottom of the chassis.
    • Step 2: Insert the other side of HDD cable into the slot on the bottom of the chassis.
    • Step 3: Combine the chassis with the HDD kit housing and then lock with screws.
  • HDD Kit Combination
    • Step 1: Get the HDD module ready. Insert power cable and HDD cable into the slots on the HDD module.
    • Step 2: Get the bracket ready.
    • Step 3: Attach the rubber shock absorbers to the bracket as illustration shown below.
    • Step 4: Fasten the HDD module to the bracket with screws.
    • Step 5: Get the screws ready, by matching them up with a washer. Meanwhile, place the HDD kit into the HDD kit housing and then screw the HDD kit to the HDD kit housing.
  • Cable Insertion
    • Step 1: Open the HDD cover by loosening the screws on the bottom of the chassis.
    • Step 2: Insert the other side of HDD cable and power cable into the slots on the bottom of the chassis.
    • Step 3: Combine the chassis with the HDD kit housing and then lock with screws.
• AEC-6860 ch4-0617-1.pdf
  • Driver
    • Setup RAID Management
• AEC-6860 Appendix A Watchdog Timer-0503.pdf
  • Programming the
• AEC-6860 Appendix B IO Information-0503.pdf
  • I/O Information