AAEON AEC-206 - Manual (Page 22)

W a l l m o u n t C h a s s i s A E C - 2 0 6
Appendix A Front Panel Daughterboard and Backplane A-3
Power Connector(CN1)
This power connector is used for AT mode with ATX power supply.
Pin Signal
1 +5VSB(AT Mode on ATX Power Supply)
2 +5V ( AT Mode on ATX Power Supply )
3 PS_ON ( AT Mode on ATX Power Supply )
4 GND ( AT Mode on ATX Power Supply )
I/O Connector(CN2)
Pin Signal
1 PWRSW_P1 ( ATX Mode )
2 PWRSW_P2 ( ATX Mode )
3 PWRLED+ ( ATX Mode )
4 PWRLED- ( ATX Mode )
5 IDELED+
6 IDELED-
7 RESETSW_P1
8 RESETSW_P2
Note: Negative is white cable and all other cables are positive.
A.3 Backplane
AEC-206 comes with one backplane for expansion. You can select
either BP206SI-V60 or BP206SG-P3-V61 based on your
application.
Backplane
Model No. Slots per Segment
(PIS A/PCI/IS A/PICMG)
Segment
(Systems)
BP206SI-V60 0/0/6/0 Single
BP206SG-P3-V61 0/4/1/2 Single