ABUS FU8200 Secvest 2WAY Wireless Info Module - Manual (Page 38)

38
7.3. Attaching the rear housing wall
1. Using the base plate as a drilling template, mark
the drill holes on the wall. Drill the holes and
insert wall plugs if necessary.
2. Feed the connection cable of the PSU into the
device and screw the rear housing side onto the
wall.
7.4. Allocating the Secvest to the info
module
1. Firstly ensure that no jumper is inserted on the
info module. Attach the power supply to the info
module (the polarity of the terminal block is
printed on the PCB). The lower seven LEDs
flash. Learning mode is now active.
2. In the installer menu of the wireless alarm centre,
select the “Other Devices

Info Module/Int
Siren

Teach Device” menu point.