ABUS TVCC40000–TVCC40030 - Manual (Page 21)

21
6. Mounting
6.1 Mounting of the camera
Attention!
During the assembly the camera must be separated from the mains voltage.
Note!
The sunshield can be removed optionally. Please loosen the fixing screw at the
top of the sunshield to remove the sunshield.
6.1.1. Please loosen the fixing screw at the
top of the counter nut, using the
supplied hexagon wrench.
Please loosen the counter nut by
rotating the nut anti-clockwise, by using
a suitable tool or wrench.
The camera module now can be
removed from the camera bracket.
6.1.2. Put the camera bracket on a desired
position, and please route the cable as
described in chapter 6.2.
Please use the supplied installation
material to fix the camera at desired
position.
6.1.3. On putting back the camera module to
the bracket, please take care of the
alignment of both parts.
The inner side of the camera
connection and the bracket front are
flattened at one position. Those
positions must match.
Those flattened positions are marked with
red color!
Now screw the counter nut back and fix it by
using the supplied hexagon wrench!