Aeromotive 17245 - H_O CARBURETED FUEL PUMP KIT - Manual

AEROMOTIVE
Part # 17245
H.O. Fuel System
INSTALLATION INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and
repair procedures. We recommend that this installation be carried out by a qualified
automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a
well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,
prohibit smoking and eliminate all sources of ignition in the area of the vehicle before
proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sprayed gasoline .
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and
precautions for relieving the fuel system pressure
.
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
This kit contains the following parts:
1 ea p/n 11219 Pump
1 ea p/n 12324 Filter
1 ea p/n 16301 fuel pump wiring kit
1 ea p/n 15605 AN-06 / AN-08 Reducer union
2 ea p/n 15610 AN-08 / AN-010 Reducer union
2 ea AN-08 o-rings
2 ea AN-10 o-rings
16 ft AN-06 stainless steel braided line
4 ft AN-08 stainless steel braided line
2 ea AN-06 straight hose end
1 ea AN-08 straight hose end
1 ea AN-08 90-degree hose end
12 ea tie-wraps
6 ea Cushioned line clamps
6 ea self tapping screws
If you are using a stock fuel tank, install a reservoir style sump in the bottom-rear of your fuel
tank. Exercise extreme caution and follow all manufacturer’s recommendations when
installing a reservoir style sump.
If you choose not to install a reservoir style sump, then you must install a high flow capacity
fuel tank pickup.(Installing a high flow pickup instead of a reservoir style sump may
shorten the fuel pump life and cause driveability problems. Stock fuel tanks have a small
inlet reservoir that is quickly emptied by a high flow fuel system, causing pump starvation
and cavitation. When using a pickup, you should maintain at least ½ tank of fuel in the
vehicle at all times, to avoid emptying the stock inlet reservoir.)
The following steps are typical of most installations:
Section 1 - Fuel pump installation
Section 2 – Fuel line hose end installation
Section 3 – Electrical Installation
Section 4 – Final checks and system start-up