Aeromotive 17204 - A2000 CARBURETED FUEL SYSTEM (DUAL CARB) - Manual

AEROMOTIVE
Part # 17204
A2000 Fuel Pump / 4 Port Regulator System
INSTALLATION INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive systems and
repair procedures. We recommend that this installation be carried out by a qualified
automotive technician.
Installation of this product requires handling of gasoline. Ensure you are working in a
well ventilated area with an approved fire extinguisher nearby. Extinguish all open flames,
prohibit smoking and eliminate all sources of ignition in the area of the vehicle before
proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as needed to
protect yourself from debris and sprayed gasoline .
WARNING!
The fuel system is under pressure. Do not open the fuel system until the pressure has
been relieved. Refer to the appropriate vehicle service manual for the procedure and
precautions for relieving the fuel system pressure
.
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
This kit contains the following parts:
1 ea p/n 11202 Pump
1 ea p/n 12304 Filter
1ea p/n 13203 Regulator
4 ea p/n 15201 Dual feed Carburetor Adapter
4 ea p/n 15606 AN-06 cutoff
1 ea p/n 15607 AN-08 cutoff union
5 ea p/n 15608 AN-10 cutoff union
1 ea p/n 15617 AN-10 Plug
2 ea p/n 15626 AN-06 Plug
1 ea p/n 16301 fuel pump wiring kit
6 ea AN-10 O-rings
1 ea AN-08 O-rings
6 ea AN-06 O-rings
20 ft AN-10 stainless steel braided line
4 ft AN-08 stainless steel braided line
8 ft AN-06 stainless steel braided line
2 ea AN-06 straight hose end
6 ea AN-06 90-degree hose end
1 ea AN-08 straight hose end
1 ea AN-08 90-degree hose end
4 ea AN-10 straight hose end
2 ea AN-10 90-degree hose end
12 ea tie-wraps
This fuel pump is for race only applications and should not be used for street use!
This fuel pump must be used with a racing style fuel cell.
If you choose not to use a racing style fuel cell, you must install a reservoir style sump in the
bottom-rear of your fuel tank. Exercise extreme caution and follow all manufacturer’s
recommendations when installing a reservoir style sump.
The following steps are typical of most installations:
Section 1 - Fuel pump installation
Section 2 – Fuel Pressure Regulator installation
Section 3 – Fuel line hose end installation
Section 4 – Electrical Installation
Section 5 – Final checks and system start-up