Aeromotive 17158 - COBRA JET COMPLETE FUEL SYSTEM User Manual
Page 5
Figure 1-7
1-15. Once you have both bulk heads installed, assemble a hose with a 45-degree fitting on one end and a straight on the
other. This line will connect to the outlet of the fuel filter (45-degree hose end) and one of the bulk heads you just
installed.
1-16. Finish up the last line by assembling a hose with a straight hose end on one side and a 90-degree on the other.
This hose will make the connection from the return bulk head in the engine bay to the return bulk head in the trunk.
1-17. Now use the cushioned hose clamps to attach the lines to the body of the vehicle. Note: Be sure to route all fuel
lines clear of any moving suspension or drivetrain components and any exhaust components! Protect fuel
lines from abrasion and road obstructions or debris.
1-18. For pump wiring, use Aeromotive part # 16301.
Section 2 – Engine Fuel Install:
The following steps are typical of most installations:
2-1. Remove the air intake ducting from the throttle body.
2-2. Note the location of and remove any vacuum lines connected to the air intake and position them out of the way.
2-3. Unplug the TPS sensor and drive-by wire connector, which is typically located on top of the throttle body.
2-4. Remove the throttle body by removing 4 screws.
2-5. Now remove the blower inlet tube by removing the 4 bolts.
2-6. Check for any dirt or debris around the fuel injectors. If any is evident, wash it off with some solvent parts cleaner or
wipe it off with a clean shop towel.