Aeromotive 13207 - MARINE A1000 BYPASS REGULATOR - Manual (Page 3)

Thanks for purchasing another quality product designed, engineered and manufactured in
Kansas City, USA!
AEROMOTIVE, INC.
7805 Barton Street, Lenexa, KS 66214
913-647-7300 fax 913-647-7207
12. Reconnect the battery and turn the fuel pump ON WITHOUT starting the car. After several seconds,
check the fuel pressure. If there is no fuel pressure, turn the fuel pump OFF, wait one minute, turn the
fuel pump ON, and recheck the fuel pressure. Repeat this OFF and ON procedure until the fuel
pressure gauge registers fuel pressure.
13. With the fuel pressure gauge registering fuel system pressure, check for fuel leaks from and
around the Aeromotive regulator and all fuel lines and connections near the regulator! If any
fuel leaks are found, turn the fuel pump OFF, remove any spilled fuel and repair the leak before
proceeding!
14. Once the fuel pressure gauge registers fuel system pressure and there are no fuel leaks, start the
engine and adjust the regulator to the desired fuel pressure (Regulator is adjustable from 3-15 psi).
Turning the adjustment screw clockwise will increase fuel pressure.
15. Once the desired fuel pressure is achieved, tighten the regulator adjustment jam nut.
16. If you do not want to keep the fuel pressure gauge on the vehicle, relieve the fuel system pressure as
instructed in the appropriate vehicle service manual. Remove the fuel pressure gauge and reinstall the
1/8 NPT pipe plug into the regulator gauge port, using thread sealant.
17. Test drive the car to insure proper operation and re-check the fuel system for leaks. If any leaks are
found, immediately shut off the engine and repair the leak(s)!