Aeromotive 13155 - PLATINUM SERIES COMPACT EFI REGULATOR - Manual

AEROMOTIVE Part # 13105
INSTALLATION
INSTRUCTIONS
CAUTION:
Installation of this product requires detailed knowledge of automotive
systems and repair procedures. We recommend that this installation be carried
out by a qualified automotive technician.
Installation of this product requires handling of gasoline. Ensure you are
working in a well ventilated area with an approved fire extinguisher nearby.
Extinguish all open flames, prohibit smoking and eliminate all sources of ignition
in the area of the vehicle before proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as
needed to protect yourself from debris and sprayed gasoline.
WARNING!
The fuel system is under pressure. Do not open the fuel system until the
pressure has been relieved. Refer to the appropriate vehicle service manual for
the procedure and precautions for relieving the fuel system pressure.
NOTE: Testing the enclosed regulator by applying air pressure or vacuum to the vacuum port with a
hand-held pump will yield poor results, due to the slight air leakage through the adjustment screw
threads. This minute leakage, which is typical of all adjustable fuel pressure regulators, does not, in any
way, affect the performance of the regulator.
The enclosed Aeromotive regulator utilizes one AN-06 style inlet fitting, located on the side of the
regulator and one AN-6 style bypass fitting, located on the bottom of the regulator; these
regulator fittings are NOT PIPE THREAD and utilize NO THREAD SEALANT. To use the enclosed
regulator in your vehicle’s fuel system, you must install the necessary adapter fittings and o-
rings, high pressure fuel lines and/or fuel injector rails to adapt your system to the configuration
and ports of this regulator. The following instructions assume that your fuel system has already
been configured for use with this regulator.
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
The following steps are typical of most installations:
1. Once the engine has been allowed to cool, disconnect the negative battery cable and relieve the fuel system
pressure.
2. Remove any cosmetic covers necessary to allow access to the fuel pressure regulator.
3. Remove the vacuum line from the regulator.