Aeromotive 18670 - A1000 CORVETTE STEALTH KIT User Manual
Page 9
23. Lower the pump assembly into the tank. Once the pump has cleared the opening, use the string to pull the 90 degree
hose end up and out of the tank. Attach the 90 degree end to the 6AN port on the pressure shaft. Noting the position
of the float arm from step 15. Index the arm in the stock location by rotating the whole pump assembley. Failure to do
so will result in a check engine light and require you to drop the tank again. FIGURE 1-14
FIGURE 1-14
24. Replace the lock ring back on the top of the fuel pump assembly. Cut or slice the factory fuel level wires and attach
them to the fuel level studs. Make sure you use stranded, insulated copper wire, with matching crimp-type connectors
for all connections.
25. Locate the OEM fuel pump supply wires, located near the OEM fuel pump mounting location. Using that supply wire,
connect the Aeromotive fuel pump as shown in the following diagram.
Hooking the factory wiring directly up the Aeromotive unit could result in wiring damage or pump failure.
26.
Before placing the tank back in the car, connect your choosen feed and return line to the pump top hat and route them
out towards the drivers side. Now put the tank back in the car and reverse the steps of disassembly.