Alera Lighting LM6R G SG - Manual (Page 2)

© 2013 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
Page 2/2 Rev. 02/18/13 LED, rEcEssED / micro6 LED, micro6 G, SG TiD
micro6 grid, slot grid
Technical installation Data
inStallation inStructionS
lenS reMoVal inStructionS
lenS inStallation inStructionS
1. Adjust Grid opening to prescribed dimensions.
2. Remove shielding from fixture and set aside.
3. Remove supply wire access plate from top of fixture housing.
4. Attach access plate to supply flex.
5. Raise fixture to ceiling. Make electrical connections to fixture and reattach access plate.
6. Pass fixture over Grid and lower until the fixture is flush with ceiling.
7. Install lamps in fixture (fluorescent only).
8. Install shielding.
1. Remove the lens by placing a small, flat blade screwdriver in between the long side of the lens and housing at either end of the housing,
and then gently pry down.
2. Once lens has been partially dislodged from housing, gently pull down by hand and lay lens aside. Be careful not to scratch the lens.
1. Install lens by lining up one side of lens edge to the raised ridge on one side of fixture.
2. While holding lens against side of fixture, rotate other side lens up to engage raised ridge on opposite side of fixture. Start in middle of
the fixture and work your way out to both ends until lens is completely secure.