Alera Lighting AL1066 - A+CLASS Quick Start Guide User Manual

Alera Lighting Lighting

Advertising
background image

Shown with

General / A/V, and

Study Time

Optional Dimming Functions available up to 4 rows. Plug into orange port number which corresponds to dimming
lighting row. Dimming functions require 0-10V dimming ballasts. PLK shown below. Light fixture styles may vary.

Whiteboard Switch

Master On/Off Control

Main Power Feed In

Row On/Off Control

• One connection required for each participating row
• Requires 0-10V dimming ballast
• 1-4 zones Daylight Harvesting zones available

• One connection required for each row with Teacher A/V or

GEN Dimming

• Requires 0-10V dimming ballast

• Any row which utilizes both Daylight Dimming and Teacher

A/V or GEN Dimming

• One connection required for each participating row
• Requires 0-10V dimming ballast

Daylight Sensor

Row 1 General / A/V Light Fixtures

Row 2 General / A/V Light Fixtures

1 Whiteboard Connection

Occupancy Sensor

Daylight Dimming

Teacher Dimming

Combined Daylight Dimming and Teacher Dimming

If separate from

Teacher Station

Plug into any Green port

Plug into any White port

Teacher Station

Accommodates up to 4 rows (2 rows shown). Lighting fixture styles may vary from those shown below.

For recessed General and A/V lighting options contact factory.

Low VoLtage ConneCtions

CLassroom ControL moduLe (CCm)

Line VoLtage output ConneCtions

Parawash (PW) Recessed Option

Microlyne Aysmmetric (MA) Suspended

A+CLASS™ SD Card ships installed.

Quick-To-Install™ (QTI) Connector

Connect male QTI connector (A) to female
orange dimming cable QTI connector
(B).
Return orange cable with CAT5 connector
to CCM. Row Jump connector (C) only,
not required in continuous row lighting
applications.

Low voltage dimming cable with QTI (A)
and CAT5 connectors (B or C) provided.

Note: Place dimming low voltage CAT5

connector into corresponding row port.

Low voltage feed cord with two QTI
connectors on one end (provided). QTI to
orange CAT5 at right (A), QTI to connect
virtual “row” (B); used for recessed or
singles only. Attach low voltage wires as
per wiring diagram provided with lighting
fixture.

Advertising