Alera Lighting APCS SLS - Manual (Page 2)

Page 2/4 Rev. 07/16/13 curves / SLS-APCS TID
sLs - A+CLAss
SLS, Solaris Direct/Indirect Technical Installation Data
© 2013 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
US Patent #8,436,542
fixtuRe connections
suspension attachMent
Connection Instructions
1. Install first fixture of row with two hangers.
2. Place bolts through openings in internal end cap.
3. Slide diecast coupler over end of fixture with bolts. Screw
bolts through threaded holes in coupler to retain coupler.
4. Slide other fixture onto bolts and attach nuts.
5. Repeat steps 2, 3 and 4 until row is complete.
6. At the end of the row attach diecast end caps with
appropriate nuts.
Suspension Instructions
1. Set bottom nut to desired fixture height.
2. Slide cable hanger into hanger slot.
3. Secure and tighten upper nut.
4. Push plunger down to adjust cable to proper
suspension. Cut excess cable.
5. For fine-tuning of fixture balance, slide
knuckle across yoke. Twist cable gripper to
lock in place.
Screw
Nut
Diecast Coupler
Cable
Gripper
Plunger
Yoke
Nut