Alera Lighting APCS CCM - Manual

Page 1/2 Rev. 07/16/13 72-00432 Integrated Controls / A+CLASS ™ CCM MOUNTING/INSTALLATION GUIDE TID
A+CLASS ™ CCM MOUNTING/INSTALLATION GUIDE
Technical Installation Data
© 2013 Alera Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Alera Lighting reserves the right to change specifications
without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com
US Patent #8,436,542
Use in conjunction with Quick Start Guide and Line Voltage
Wiring Diagram provided with the CCM and included on the
A+Class™ SD Card.
CCM Housing must be located in plenum, electrical closet, or other secure
location. Temperature rating is 0ºC to 40ºC.
Precaution: installation must be performed by qualified professional electrician in accordance with all local,
state and national codes.
fasteners (by others)
Circuit Board
Housing
fasteners (nuts provided)
figure 1
1. Use a 7/16" nut driver to remove the four backplate retaining nuts.
2. Remove the whole backplate / circuit board assembly from the
enclosure. Note: Do not remove the circuit boards from the
backplate. (see figure 1).
3. Mount the box to the surface.
4. Install the whole backplate / circuit board assembly into the
enclosure.
5. Use a 7/16" nut driver to attach the four backplate retaining nuts
into place.
6. Wire the unit per instructions. See wiring diagram on back.
(See reverse side for line voltage wiring diagram examples)
Backplate remains attached.
(Refer to figure 1)
3